GPS RECEIVER- Yamaha YZF-R1
Installation and instruction manual.
Positioning
The GPS receiver shall be secured to the vehicle by means of the specific Dual
Lock adhesive system supplied. The code label shall be turned upwards so that the
internal antenna will have the maximum sky visibility. Avoid or reduce to a minimum
the parts of the vehicle that may shield the receiver in its visibility upwards. It can be
installed in a quite open area of the top front fairing or on the fork plate.
Connection
Remove the left side of the
fairing and connect the GPS
RECEIVER with the two multi-pole connectors of the same model that you can
find on the left of the radiator, in order to make a bridge as shown in the picture.
Operation and setup
When supplied, the receiver will start searching for visible satellites. During this
phase, the RED LED light is fixedly on. After having identified an adequate
number of satellites, the LED will slowly blink. Now, you can enter the
coordinates of the finish line simply by pressing the button near the LED when you are crossing the finish line of the track. This
operation can be performed both at a halt and when moving. If performed when moving, the system will also acquire the direction of
running and it will avoid detecting a false finish line on very narrow tracks (typically Kart or Motocross tracks) where there is a
counter straight stretch close to the main straight stretch, but opposite to it. Setup can be also performed at a halt on normal speed
tracks.
When the finish line is acquired, the LED is blinking quickly. This means that the finish line is within a reach of 5 km.
The GPS Receiver will store the finish line coordinates last used even if disconnected. It is necessary to set up a new finish line only
when you change the track.
Attention: when you restart after having moved a lot of kilometres, the receiver may even take some minutes (5-6)
to acquire the satellites and let the LED blink. At the power on, it is always recommended to place the vehicle in an open area where
it has got the sky visibility necessary to acquire the GPS signal as quickly as possible.
Note:
In order to display the acquired Laptimes you must activate the Lap functions on the original dashboard by following the Yamaha
handbook indications.
LED operation
RED LED ON FIXED: Receiver searching for satellites
RED LED SLOW BLINKING: Satellites properly acquired, press the button on the finish line to set up the end-of-lap.
RED LED QUICK BLINKING: Satellites on sight and finish line within a reach of 5Km, the system can detect the crossing of the finish
line you have setup.
Product notes
a-
The system is completely water resistant
b-
Not approved for road use.
This product is covered by a 24 month warranty against manufacturing defects.
Any update to the present manual is available on the website
Starlane
s.r.l. Via Madonna delle Rose, 70 - 24061 Albano S. Alessandro (BG) – Italia e-mail:
