Starke FUN BBQ Meat Master, Инструкция по эксплуатации

Страница: 7 / 15

English
7
Connecting the Gas
Once you have placed the Meatmaster in a location that satisfies the above-mentioned safe -
ty instructions, you can start connecting it with the gas cylinder.
The gas cylinder must be placed in an upright stable position at a distance from the Me-
atmaster without over-stretching the tube and without touching parts of the Meatmaster
at any point. But at the same time it should be so far away so that heat radiation from the
Meatmaster does not reach the surface of the gas cylinder or the gas tube.
Now you must connect the pressure regulator to the gas cylinder‘s valve.
Follow the instructions supplied with the gas pressure regulator.
ATTENTION:
If the tube has a maximum prescribed period of use, if the local regulations require it and/or
it is expired or shows porous or damaged areas, replace it. If you smell gas during the Meat
-
master‘s operation or suspect any leakaeg of gas-bearing components, you must cut off the
gas supply immediately. You may start the Meatmaster again only after rectifying the cause
of leakage.
Leak Test
You must carry out a leak test for all gas-bearing components after connecting the gas cy-
linder for the first time, every time after changing the cylinder or a prolonged gap. For this
purpose, you can use a comercially available leak detection spray.
Turn on the gas supply and use the spray according to the manufacturer‘s instructions.
Do not use a naked flame to detect leaks under any circumstance.
If you detect a leaky connection, turn off the gas supply immediately and retighten the cor-
responding connection. Run the leak test all over again.
If you are unsure on how to connect the gas cylinder and the tube, or you are doubtful
about the leak test, please get a qualified technician to do the job of connecting the gas-
bearing components.