background image

15°
15°

Owner’s Manual

-3-

-4-

Location of Front Channel Speakers 

Three loudspeakers are to be placed across in the 
front of the listening room for the home theater 
system. The width of the stereo image is 
determined by the distance between the left and 
right speakers. The image will be too narrow if the 
speakers are placed too close together and, 
conversely, if placed too far apart, the blend will 
suffer creating a void in the middle section. 

Your speakers should create a continuous "virtual 
image" when properly placed from left to right. As a 
result an illusion of sound outside, in front of, and 
behind the speaker systems will be created. 

Starke Sound recommends a 45 degree to 60 
degree angular separation when viewed from 
above. The distance between the speakers is 75% of 
the distance from the speakers to the listener at the 
minimum 45° separation. At the maximum 60° 
separation the distance between the speakers is 
equal to the distance from the speakers to the 
listener. 

Location of Surround Speakers 

Starke Sound has provided the following information for the placement of surround 
speakers. Although there are many opinions regarding placement and location of 
surround speakers Starke Sound has provided the following recommendations based on 
thorough research, academics, and our experience with many installations. Note: The 
choice of models used in the illustration below is arbitrary. The information described in 
the illustrations can be applied to both the IW and the IC series covered in this manual 
and in any of the surround locations. However, please keep in mind that the 
midrange/tweeter array in the IC-H7 and IW-H7 must always be vertically oriented. 

If two surrounds are used in a standard 5.1 configuration (not 7.1 or EX), they are best 
mounted directly to the sides of the primary seating location, preferably within ±15° (see 
illustration). This placement is the preferred method over back wall mounting for a few 
reasons: 1. the placement of the surround speakers are located where the ear's ability to 
discriminate left from right is optimum. This produces the maximum sense of 
"envelopment" being surrounded by sound, 2. Mounting the rear speakers behind the 
listener increases the angle between the front and rear speakers. This results in 
reducing the chance that there will be a continuous front-to-rear sound image, lastly, 3. 
Since our ability to discriminate the front-to-rear location of a sound source is not very 
strong, locating surround speakers to the side of the listener will improve the listening 
experience. 7.1 or EX systems that use side and rear speakers together overcome all of 
these obstacles and give both maximum envelopment and a more continuous surround 
effect. 

In order to create a seamless sound image across the front of the speakers one must 
carefully consider location and placement. 

Optimally, there should an equal distance from the left, right, and center channel 
speakers to the listener location.  

The height of the midrange/tweeter module of the front channel speakers should be 
installed as close as possible to the height of a seated listener's ears. The front channel 
tweeters should be located within two vertical feet of that height. 

LISTENING

AREA

45° - 60°

Alternate Surround Speaker Locations

Preferred Surround Speaker Locations

Содержание IW-H7







Отзывы: