5
Installation of the wheel guard
Always be sure that the tool is switched off and unplugged before attempting to
perform adjustment.
Install the wheel guard (1) in the position convenient for operating. Make sure that it
occupied the proper position and is not loose.
The wheel guard must be fitted on the tool so that the closed side of the guard always
points toward the operator.
Installation of the side handle
Attach the side handle firmly into the desired position. It can be installed in any of the
three locations on the machine’s housing.
Installing or removing the grinding disc
Attention
!
Always be sure that the tool is switched off and unplugged before attempting to
perform adjustment.
Use only the discs of well-known manufacturers
before expire date that is indicated on the package.
Remember, that disc’s properties are greatly
influenced by the conditions of storage.
Mount the wheel guard on the inner flange and put the
outer flange onto it.
To screw up the disc securely press the shaft lock to stop
the wheel and use wrench after that.
IMPPORTANT
:
put the protruding part of the
outer flange close to disc if you mount sanding disc, put
the protruding part of the outer flange outside if you
mount cut-off disc.
To remove wheel guard, follow the installation procedure in reverse.
Warning
!
Press the shaft lock only when the spindle is not moving.
Operation
Use only the discs of the size indicated on the name plate of the tool.
Autogoods “130”
130.com.ua
