5
Before setting of a drilling bit make sure that the tool is switched off.
Setting of the drilling bit and depth gauge
Insert the drilling bit of the proper size in the chuck for the whole depth. Fix it inside by the way
of turning of the chuck around itself. Put the key in the one of the three holes aside the chuck and
screw it up turning clockwise. Make sure that all the three holes are screwed up evenly.
For removing of the drilling bit put the key in the one of the three holes aside the chuck and
screw it down turning counterclockwise.
Insert and fix the depth gauge.
Setting of the rotation speed
Set up the desired rotation speed according to the features of the material to be processed by the
way of turning the rotation speed adjustment wheel.
Setting the mode of operation
Set up the desired mode of operation by the way of Drilling/impact drilling mode switch.
Don’t use in the impact drilling mode the bits that are not for concrete and stone
drilling.
Don’t use
impact drilling mode for the drilling in the wood, plastic and metal.
Switching on
Check all the switches of the machine before switching on. Check the drill in no-load mode for
10-15 seconds.
During the operation
during long work don’t allow overloading and overheating of the motor, make work
breaks;
avoid mechanical damage of the machine;
keep the machine away of intense heat sources and reactive materials, don’t allow liquids
and other matters come inside the machine;
don’t not block ventilation slots in the housing;
switch off the machine by the way of turning off the switch before disconnecting the cable;
avoid overheating of the drilling bit;
switching of the rotation direction can be made only after full stop of the motor.
After work
switch off the machine and disconnect the cable from the current source;
Autogoods “130”
130.com.ua
