Stark 66012, Инструкция по эксплуатации и правила безопасности

Страница: 4 / 14

3
MOTOR SPECIFICATIONS
The Wood Lathe is designed to use a 3400 RPM motor only. Do not use a motor that runs faster than
3400 RPM. This Wood Lathe is wired for operation on 110-120 volts, 60Hz alternating current.
To avoid injury from unexpected start-up, do not use blower or washing machine
motors or any motor with an automatic reset overload protector.
CONNECTING TO A POWER SOURCE
This machine must be grounded while in use to protect the operator from electric shock. Plug the power
cord into a 110-120V grounded type outlet protected by a 15-amp dual element time delay fuse or circuit
breaker.
Not all outlets are properly grounded. If you are unsure if your outlet is properly grounded, have it
checked by a qualified technician prior to using this tool.
Failure to properly ground this tool can cause electrocution. If shocked, your
reaction could cause your hands to hit the cutting tool.
Of the power cord is damaged in any way, have it replaced immediately to avoid
shock, injury or fire hazard.
MOTOR SPECIFICATIONS AND ELECTRICAL REQUIREMENTS
This Wood Lathe tool is equipped with a 3-cinductor cord and grounding plug. The ground conductor
has a green jacket and is attached to the tool housing at one end and to the ground prong in the
attachment plug on the other end. This plug requires a mating 3-conductor as pictured below. If the outlet
you are planning to use for this power tool is of the 2-prong type,
DO NOT REMOVE OR ALTER THE
GROUNDING PRONG IN ANY MANNER. Use an adapter as shown and always connect the grounding
plug to known ground. It is recommended that you have a qualified electrician replace the 2-prong outlet
with a properly grounded 3-prong outlet.
The green grounding plug extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box.
DIAGRAM AND SPECIFICATIONS