Stark 66012, Инструкция по эксплуатации и правила безопасности

Страница: 3 / 14

Dress properly. DO NOT
wear loose clothing, dangling objects, or jewellery. Keep your hair, clothing
and gloves away from moving parts. Loose clothes, jewellery, or long hair can be caught in moving parts.
Air vents on the tool often cover moving parts and should be avoided.
Wear the proper personal protective equipment when necessary. Use ANSI Z87.1 compliant safety
goggles (not safety glasses) with side shields, or when needed, a face shield. Use a dust mask in dusty
work conditions. Also use non-skid safety shoes, hard-hat, gloves, dust collection systems, and hearing
protection when appropriate. This applies to all persons in the work area.
DO NOT overreach. Keep proper footing and balance at all times.
2
Check for damaged parts before each use.
Carefully check that the product will operate properly and
perform its intended function. Replace damaged or worn parts immediately. Never operate the product
with a damaged part.
DO NOT use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
Disconnect the power/air supply from the product and place the switch in the locked or off
position before making any adjustments , changing accessories, or storing the tool. Such preventive
safety measures reduce the risk of starting the tool accidentally
Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with another tool.
Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Keep guards in place and in working order.
Never operate the product without the guards in place.
DO NOT leave the tool running unattended.
Always wear the proper protective equipment including ANSI Z87.1 compliant eye protection, NIOSH
compliant breathing protection, anti-vibration work gloves, steel toed work boots, and a helmet.
Remove adjusting keys and wrenches. Form a habit of making sure keys and wrenches are
removed from the tool before turning it on.
NEVER stand on the tool. Serious injury can occur if the tool is tipped over or if the cutting tool is
contacted.
Maintain tools with care. Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and changing accessories.
DO NOT alter or misuse the tool. These tools are precision built. Any alteration or modification not
specified may result in a dangerous condition.
Avoid gaseous areas. Do not operate electric tools in an explosive or gaseous atmosphere. The motor
in this tool normally spark and could react creating a dangerous situation.
WARNING: Before connecting the tool to a power source be sure the voltage supplied is the
same as that specified on the nameplate of the tool. A power source with a voltage greater than
that specified for the tool can result in serious injury and could damage the tool. If in doubt, DO
NOT PLUG THE TOOL IN. Using a power source with a voltage less than the nameplate rating is
harmful to the motor.
IMPORTANT SAFETY INFORMATION