J
SOHORAID ST4-TB3 User Manual
2
Front and rear view
3. Hardware Requirements and Precautions
1. This system can only transfer data to one computer through one interface at a time.
2. Please make sure that the hard drives are free from bad blocks or defects prior to installation in
order to avoid system crashes or data loss.
3.
Whenever turning off or unplugging the ST4-TB3 from your computer system becomes necessary,
always remember to safely remove it from your operating system first.
4. When the ST4 is connected to the computer system, it's prohibited to remove, insert or swap the
hard drive while data transfer is being performed.
5. If you will be incorporating either software or hardware RAID functionality to operate with the ST4-
TB3, it is important to understand the RAID level and its component that will be incorporated and
the precautions to take as each RAID level and component may function differently and contains
various limitations.
6. It is highly recommended for users to back up important data contained within the drives of the
ST4-TB3 on a regular basis or whenever the user feels necessary to a remote or a separate
storage device. STARDOM will not be responsible for any lost of data caused during the use of
the ST4-TB3 or the recovery of the data lost.
A. HDD access light
B. HDD enclosure handle
C. HDD enclosure keyhole
D. Power status light
E. System status light
F. Thunderbolt port
G.
Mini DisplayPort
H. Anti-theft lock
I. Fan
J. Fan speed switch (set to "High" by default)
Front View
Hard Disk
Location 0
Hard Disk
Location 1
Hard Disk
Location 2
Hard Disk
Location 3
Note: A hard disk must be installed at HDD location 0
Rear View
K. Mute switch
L.
Power switch
M. Power socket
