Stardom SOHORAID SR2, Руководство пользователя

Страница: 8 / 35

SR2 Series User Manual
6
6. Hard Drive Replacement Instructions
RAID-1 degraded
Pri : X Sec : O
RAID-0 failed
Pri : O Sec : M
In normal operational state, if the LCM "Pri: X" or "Sec: M" and the audio alarm activates, this would
indicate that the hard drive may be malfunctioning.
When this happens, you may choose to disable the audio alarm by pressing the MUTE button
located at the front of the system and continue to operate the system normally.
When finished, you may restart the SR2 to double check and see if the drive is in fact malfunctioning.
If you are certain that the drive is in fact malfunctioning, follow the instructions below to complete the
replacement of the malfunctioning drive.
Step 1
Step 2
Shut off the SR2 power. Extract the driveing "X/M" on the LCM from the corresponding drive
position and replace it with the new replacement drive. Do not switch the positions of the
drives.
Once the replacement is complete, turn on the power of the SR2. When the system
completes initialization, the LCM will ask you if you wish to initiate the rebuilding procedure.
Primary drive damage
Secondary drive lost
Pri : HDD Insert
Sec HDD : OK
Pri : HDD Insert
Sec HDD : OK
Rebuilding
Sec → Pri 32%
Rebuilding
Sec → Pri 32%
OR
7. Data Rebuild
During the use of SR2, if you are required to replace a malfunctioning drive refer to chapter 6 "Hard
Drive Replacement Instructions".Once drive replacement is complete and you power on the SR2, the
system will perform data reconstruction.
The data rebuild processing time is based on the capacity of the drive. During procedures, we
suggest to not use the system until the procedure(s) is complete as use of the system during
procedures may cause delays to the processing time.Please wait until the procedure(s) has been
completed to continue use.
During the data rebuilding process, the LCM panel will display the percentage progression rate of the
rebuild. Below are sample diagrams.