Remote Devices
31
Simulation Kit Manual
Figure 19 Mounting the Net-960E
To attach the control box:
1.
Connect the Net-960E control box cable (9 pin connector) to the SER 1 connector
on the Net-960E.
2.
Connect the Net-960E control box cable (RJ 45) to the RS232 input pin (#15) on
the Helios.
3.
Connect the Net-960E power and ground to the vehicle battery only after you have
powered up the Helios. Turn the power switch on the control box (PWR) to ON.
MDT Activation:
·
Before activating a Mobile Data Terminal, please change the communication
rate between the Helios unit and the MDT.
·
Using an Installer application, read the unit's parameters, approach
"Hardware" tab, check the box of "Use 57600 baud rate" and send the new
parameters to the unit.
Rubber
Mounting
Pad
Rubber
Mounting
Pin
Parallel
Mounting
Holes
