6
BURNER OPERATION (MODELS 624MA,
636MA, and 648MA ONLY)
To ignite burners, turn burner valve knob to "HI"
position. Each burner is controlled by an individual
high-low, on-off valve. An infinite number of
temperatures may be obtained by turning the burner
valve knob to any position between high and low.
BURNER ADJUSTMENT (MODELS 624MA,
636MA, and 648MA ONLY)
1. Turn burner valve knob to "HI" position.
2. Slowly decrease opening of air shutters to give a
soft blue flame having luminous tips, then slowly
increase openings to a point where the yellow tips
disappear and a hard blue flame is obtained. See
Figure 3.
BURNER ADJUSTMENT (MODELS 624TA,
636TA, 648TA, 624TB, 636TB, 648TB)
1. Push dial in and set thermostat of one burner to
450°F (229.9°C).
2. Observing flame through lighting hole, close the air
shutter to give a soft blue flame having luminous
tips then slowly increase opening to a point where
the yellow tips disappear, and a hard blue flame is
obtained. Repeat for all burners.
LIGHTING INSTRUCTIONS
When griddle is first lit, it will smoke until the
preservation oils and impurities are burned off.
1. Turn off main valve to unit and wait 5 minutes to
clear gas.
2. Turn off all knobs and pilot valves and wait 5
minutes to clear gas.
3. Turn on main valve and light all pilots.
4. Turn burner knobs to desired setting.
5. To turn burners off, turn knobs off.
NOTE: The griddles are equipped with standing pilots
and should be lit immediately after the gas is turned on.
OVERNIGHT SHUTDOWN
Turn knobs to the off position to turn burners off.
OPERATING INSTRUCTIONS
SEASONING THE GRIDDLE HEATING
SURFACE (NON-CHROMIUM SURFACES)
Clean the griddle surface thoroughly removing the
preservation oil with a mild detergent and warm
water. After the griddle has been thoroughly cleaned,
it should be seasoned to prevent food from sticking.
Before using, and after each thorough scouring, season
the griddle heating surface in the following manner:
1. Turn the temperature control dial to 350°F
(174.9°C).
2. Using a clean cloth, not a spatula, spread a thin film
of cooking oil or fat over the griddle cooking
surface. This film should remain on the hot griddle
surface 1/2 hour.
3. Remove excess fat and wipe clean.
4. Apply another film of cooking oil over the hot
cooking area for another 1/2 hour, and again
remove excess fat and wipe clean. The griddle
surface should now be ready for use.
Even with careful seasoning food may, to some
extent, stick to the griddle cooking surface until
griddle plate is "broken in."
Содержание STAR-MAX 8G-624MZ-LP
Страница 8: ...12...