2M-Z19213 Rev
G
- Owner's Manual for RTW Rolling T
ortilla Warmer
3
1/2 scale RTW
control panel
DAILY OPERATION
CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND
CARE SHOULD BE TAKEN WHILE USING THIS UNIT.
THIS UNIT IS DESIGNED TO WARM DRY, FLEXIBLE PRODUCTS ONLY.
DO NOT ATTEMPT TO RUN WET OR LOOSE MATERIAL THROUGH IT.
ELECTRONIC CONTROLS
BUTTONS (PRIMARY USES)
• ON/OFF—Turns power on or off to the electrical components of the unit.
• SET/TEMP—Allows adjustment of the roller heating element temperature
up to 4
8
0°F (2
49
°C).
•
▲
/CLEAN—Accesses “CLEAN” mode and adjusts settings upward in menus.
•
▼
/RUN— Accesses “RUN” mode and adjusts settings downward in menus.
FUNCTIONS/MODES
•
ON/OFF
—All power is turned on, or removed from, the drum motor, heating
elements, and cooling fan. After powering down, the screen will
display “OFF” until the “ON/OFF” button is pressed again. Cooling
fan will be on in all modes other than when the unit is powered down.
•
PREHEAT
—Drum motor runs at the set “TORT” speed. Heaters bring the drum
temperature up to the set operating temperature.
•
TORT
—Drum motor runs at the set “TORT” speed. Heaters maintain the drum
temperature at the set operating temperature.
•
BREAD
—Drum motor runs at the set “BREAD” speed. Heaters maintain the
drum temperature at the set operating temperature. This mode only
lasts for 1–40 seconds before defaulting back to
TORT
mode.
•
COOL
— Drum motor runs at the set “TORT” speed. Heaters are off.
•
CLEAN
— Drum motor does not run. Heaters are off.
START-UP
i.
When the unit is initially plugged in, the display will read “OFF” for a brief time. No outputs will
receive power at this time.
ii.
When “ON/OFF” is pressed, the drive motor, heating elements, and fan motor will be turned on.
The
PREHEAT
mode will start immediately and will take approximately twenty (20) minutes
to complete. During this time, “PREHT” will appear on the display. Do not attempt to adjust
temperature or speed settings until
PREHEAT
has completed.
iii.
The temperature of the drum can be checked at any time in
PREHEAT
or
TORT
modes by pressing
the “SET/TEMP” button. If the temperature has not yet reached 100°F (38°C), the words “LOW”
and “TEMP” will flash on the screen.
iv.
There will be a small dot on the lower right of the screen which will remain on whenever the heating
elements are on. When the
PREHEAT
mode has completed, “TORT” will be displayed on the screen.
