Star PGC28I, Руководство пользователя

Страница: 9 / 24

2M-
Z2100
1 R
ev
- Owner's Manual f
or IR
CS4 Impingemen
t/Radian
t Split
-Belt C
on
ve
yor T
oas
ter
5
2M-
Z220
33 R
ev A Owner
’s Manual f
or PGC28I and PS
C28I S
andwich Grills
BASIC OPERATION
i. Turn the unit on by moving the power switch
to the “ON” position. The “HEAT ON” indicator
will be lit until the unit reaches the set operating
temperature. This process will take approximately
30 minutes.
ii. Once up to temperature, place product onto
the cooking surface and lower the upper platen.
iii. On timer or electronic control equipped models
only, select the desired timer setting by pressing
one of the product settings [press “START/STOP”
to begin countdown on timer and thermostat
models]. When the time reaches zero, an alarm
will sound.
iv. When the product is done cooking, raise the
upper platen to the stop position and remove
the product from the grill.
v. Scrape any excess grease or residue into the
grease chute, preferably using a non-metal
scraper. Pay attention as the grease drawer
may need to be emptied periodically throughout
daily operation.
vi. Repeat with new product or turn the power
switch to “OFF” position if the grill is not being
used further at this time.
SETTING TEMPERATURE
[THERMOSTAT ONLY OR THERMOSTAT
AND TIMER MODELS]
Turn the thermostat dial to the desired setting
to set the temperature. The elements come on
when setting “1” on the dial is reached, setting
“2” is at 175° F (79° C), setting “3” is at 200° F
(93° C), and following that each setting adds
50° F (28° C) for each position up to setting
“10” which is set at 550° F (288° C).
SETTING TIMER
[TIMER MODELS ONLY]
On timer-equipped models only, the selected
preset can be changed by holding either the “1/+”
button and pressing the “START/STOP” button
to increase time or by holding either the “2/-”
button and pressing the “START/STOP” button
to decrease time. Releasing the button that
is being held will save the change.
SETTING TIME AND TEMPERATURE
[ELECTRONIC CONTROL MODELS]
ON THIS MODEL, EACH HALF OF THE GRILL WILL
HAVE ITS OWN INDEPENDENT CONTROLS.
i. Press and hold “TEMP” [actual temperature displays].
ii. While holding “TEMP” press and hold any program
button on the for one second. The LED above the
program number will light and the display will read
“_ _ _ _”. Enter the four-digit security code sequence
4, 3, 2, 1. Once the sequence has been successfully
entered, the preset time will be displayed and the
LED for that program will begin to flash.
iii. Set the desired time with the “3/+” to increase time
or “4/-” to decrease time. Press the “TEMP” button
to save changes.
iv. The lower temperature setting will now be displayed
and can be programmed. Set the desired temperature
with the “3/+” to increase the temperature or “4/-” to
decrease temperature. Press the “TEMP” button again
to save changes.
v. The upper temperature setting will now be displayed
and can be programmed. Set the desired temperature
with the “3/+” to increase the temperature or “4/-” to
decrease temperature. Press the “TEMP” button again
to save changes.
vi. Press any other program button within 15 seconds
to continue programming without re-entering the
security code.