7
PRESET TIME AND TEMPERATURE
This 0V unit comes with an LED Timer Controller, which has four () individual program
settings. All of these programs come preset to 00°F at :00 minutes from the factory.
By following the steps below you can change a program to fit your specific needs, giving
you more flexibility in your menu offerings. For example, simply by programming a second
buttons for 0 seconds allows you to grill the opposite side for a consistent period of time.
The steps below will better familiarize you with your unit’s program capabilities.
Startup:
1. The preset time will flash until preset temperature is reached.
. When the control reaches preset temperature, time display, "Heat On" indicator and
program indicator will stop flashing and the alarm will beep three times.
Temperature:
. To view the actual temperature, press and hold "Temp Button." Display will read "Lo
F" if temperature is below 7°F (°C) and "Hi F" if temperature is above 57°F
(0°C).
Operation:
. Pressing any program button (-) will start the timer countdown and display the preset
time remaining. The LED for the appropriate program will be lit during countdown and
remain lit until another program is selected.
2. When the display reaches "00:00", the buzzer will sound and the digits will flash.
. Press the program button to silence the buzzer and return the readout to programmed
time.
. The right and left sides will operate independently of each other. Both timers can be in
operation at the same time. The "00:00" display will show which side is timed out.
Changing Program Time and Temperature:
. Press and hold "TEMP" (actual temperature displays).
. While holding "TEMP," press and hold any program button on the Left one
second, the LED above the program number light and the display reads
"_ _ _ _." Enter the four-digit security code sequence,
4, 3, 2, 1
. The security code
will
not
show on the display. Once the correct sequence has been entered, the preset time
will be displayed and the LED for that program will begin to flash.
. Set the time with the "+ or -" buttons.
.
Press the "TEMP" button to save the time.
5. The preset temperature will now be displayed.
. Set the desired temperature for this program using the "+ or -" buttons.
7.
Press the "TEMP" button to save temperature and to exit programming mode for
this program. The LED will stop flashing but will remain lit.
8. Press any other program button within 15 seconds to continue programming without
re-entering the security code.
9. While programming a program (LED is flashing), if no input is received for 15 seconds,
the unit will revert to normal operation and the security code must be re-entered.
Note: Temperature settings are done with the left side buttons
only. The time settings
programmed on the Left buttons will also be programmed onto the
right side.
See below to
make time changes to the
right side
only.
Each programming change must be saved by
pressing the "TEMP" button!
