4
CLEANING
For non-coated grids: Clean outside of baker every
day that it is in use. Do not clean grids unless a buildup
of carbon forms. In order to remove carbon from
grids, unplug the unit, place ammonia soaked cloth
over bottom grid, close and leave overnight. A wire
brush may then be used to remove the carbon buildup.
If you use a commercial carbon remover, make sure
that it is safe for aluminum.
CAUTION
DO NOT CLEAN USING A WATER JET OR
SIMILAR DEVICE FOR CLEANING. DO NOT
IMMERSE IN WATER AT ANY TIME.
CAUTION
DO NOT CLEAN TEFLON
®
GRIDS WITH
ABRASIVES. THIS WILL VOID THE
WARRANTY.
For cleaning the baker outside use only a soft cloth and
mild soap to keep the exterior surfaces bright and
shining. Do not use detergents, strong abrasives or
metal scouring pads on the exterior surfaces of the
waffle baker.
HEATING WAFFLES
1. Lift the lid and place a frozen waffle on the lower
grid.
2. Close the lid.
3. Press START/STOP to begin the countdown.
4. When the timer beeps, press START/STOP again.
5. Open the lid and remove the waffle. (Do not use
metal utensils on teflon coated waffle bakers.)
6. For the next waffle repeat steps 1 through 5.
HELPFUL HINTS
1. During long slack periods of the day, turn off the
baker. During short slack periods, leave unit on
with the grids closed. This will help minimize
carbon buildup.
2. Do not store batter in the refrigerator and expect
the same speed in baking. Cold batter will take
longer to bake.
3. For proper release of waffles it is important that
the batter contain the proper amount of shortening.
RETAIN THIS MANUAL FOR FUTURE REFERENCE
Part No. 2M-Z7735
Rev. -- 3/11/04
