Voice Indication:
Power ON: ~ “Chirp”
Bluetooth Connected: ~ Devices standard connect noise
Cos-Play / Pair / Un-Pair Mode ~ "Chirp"
Voice Recognition: ~ "Chirp" / devices standard noise
Answer / End Call: ~ “Chirp”
Reject Call: ~ Devices standard connect noise
Receive Call: ~ “Chirp”
Base LED Indicator:
Red LED flash = Low Battery
Red LED = Charging
Blue LED = Fully Charged (When USB Connected)
Blue LED Slow Flash = Connected to Bluetooth (every 5 seconds)
Blue and red LED Flashes = Unpair / Cosplay Mode (every 2 seconds)
Blue and red LED Flashes = Looking for Bluetooth connection (every 2 seconds)
Bluetooth Paring Troubleshooting:
If FT-PIN does not appear in your phone or tablets device manager make sure you are
in PAIR MODE by confirming that the RED and BLUE LED's are flashing at 2 second
intervals. If you still do not see FT-PIN in the device manager recycle the unit by turning
OFF and ON again.
Charging:
We recommend tuning off the device before charging
Connect the device and power source via Micro-USB cable
Use a 1A / 5V USB charging block or connect to your computers USB port
The Blue
LED will turn on when charging is complete
*Although we employ protection circuitry, using a higher Amp/Volt charging block than recommended may damage your unit
Power OFF: ~ “Chirp”
Wake From Cosplay:
~ “Chirp”