3.3 Memory Switch Setting
For details on the printer settings, refer to "[Setting Table] (Page 27)".
The setting change by memory switch is disabled before shipment.
Before changing the printer setting by the memory switch, enable the setting change by memory switch
using the following steps.
1. Turn on the printer power by pressing and holding down the FEED button and the POWER button
simultaneously for 5 seconds or more. The printer will perform self printing.
2. After the self test finishes, release the POWER button and the FEED button, and press the POWER and
FEED buttons simultaneously within 2 seconds. Hold down both buttons for 2 seconds or more and
release the buttons.
Start self test
5 seconds
3. If the printer prints out “Memory SW setting = Enabled”, the setting change by memory switch is
enabled.
*
When the above steps 1 to 3 are performed while the setting change by memory switch is enabled,
the printer prints out "Memory SW setting = Disabled" and the setting change by memory switch is
disabled.
Release the FEED button
and the MODE button.
Then, press the FEED and MODE
buttons simultaneously.
Within
2 seconds
Self test finishes
(By the buttons on the printer.)
Emulation : ESC/POS
Communication Port : Bluetooth(Auto)
- 22 -