Star Lights ACM-09AR, Инструкция по эксплуатации

Страница: 15 / 157


Setting Angle of Air Flow
Setting vertical angle of air flow
While the unit is on, use the SWING/DIRECT button to set the
direction (vertical angle) of airflow.
1. Press the SWING/DIRECT button once to activate the
louver. Each time you press the button, it will adjust the
louver by 6°. Press the button until the direction you prefer
is reached.
2. To make the louver swing up and down continuously,
press and hold the
SWING/ DIRECT button for 3 seconds.
Press it again to stop the automatic function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually. Grip
the deflector rod (See
Fig.B) and manually adjust it to your
preferred direction.
For some units , the horizontal angle of the airflow can be set
by remote control. Please refer to the Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at too
vertical an angle for long periods of time. This can cause
water to condense on the louver blade, which will drop on
your floor or furnishings. (See Fig.A)
When using COOL or HEAT mode, setting the louver at too
vertical an angle can reduce the performance of the unit due
to restricted air flow.
Do not move louver by hand. This will cause the louver to
become out of sync. If this occurs, turn off the unit and unplug
it for a few seconds, then restart the unit. This will reset the
louver.
13