-5-
CAUTION:
Take extreme caution not to over tighten the screws!!! Over
tightening of the screws can strip the holes.
1. Insert one of the carriage
bolts through one of the
washers.
Please note that
washer is used as a spacer
on the square neck of the
carriage bolt.
Slide the bolt
and washer through the
back of the left bracket.
Be sure to select the correct
bracket. The larger flange
should be located towards
the center of the light.
2. Remove three of the #8 x 1/2" self-
tapping Phillips pan head screws and
use them to install the left attaching
bracket on the light.
CAUTION:
Take extreme caution not
to over tighten the screws!!! Over
tightening of the screws can strip the
holes and result in a faulty mount.
3. Once the left attaching bracket is installed
securely on the light, fasten one of the
forked “L” brackets to the attaching
bracket, using the carriage bolt,
a washer, and a nut. Leave
the nut slightly loose to
allow for minor adjustments
during the remainder of the
installation.
Attach Forked Brackets to Light
4. Repeat steps 1-3 for the right attaching bracket
.
Universal Mounting (CONT'D)
