-5-
Programming
Programming is optional. If the default settings
are acceptable, skip to the Operation section.
If you will be changing any of the options on your lightbar, this should be done prior to
installation. Programmable features include the following:
•
Traffic Director or Takedown Mode
•
Pattern Selection
•
Phase Selection (which heads alternate)
•
Head Enable (which heads activate)
•
Dim Option (High-Low)
•
Program Mode (Copying all settings from one light to another)
Traffic Director /Takedown
This light has the option to operate in either Traffic Director Mode or Takedown Mode.
By default, standard ULB28 lights will be shipped with Traffic Director Mode
OFF
(UP in the
picture above), thus enabling the Pursuit, Takedown, and Title 13 functions.
If you will wish to use the Traffic Director functions of this bar (Warn, Left, Right, and Center
Out) you can move this DIP switch into Traffic Director Mode (DOWN) which will replace the
Pursuit, Takedown, and Title 13 functions with the Traffic Director Functions.
Please Note: This switch does NOT change the colors of your LEDs. Depending upon the LED
colors you ordered in the light, the color of the Traffic Director may not be desirable.
ON
CTS
1
2
3
P
ro
g
ra
m
M
o
d
e
H
ig
h
-L
o
w
/P
a
tt
e
rn
T
ra
ff
ic
D
ir
e
c
to
r/
T
a
k
e
d
o
w
n
P
h
a
s
e
P
ro
g
ra
m
m
in
g
H
e
a
d
E
n
a
b
le
P
ro
g
ra
m
m
in
g
Communication Port
There are three DIP
switches, two push-button
switches, and a telephone-
style jack, all located on
the top of the light, that
should be used to set any
of these options
prior to
installation
.
Please Note:
A small
black adhesive-backed
plastic plate (P30019-148 )
is included to cover the
opening once all
programming has been
completed.
High-Low/Pattern Option
This light is equipped with an option allowing you to dim the light for nighttime operation. If
you do not need this feature, skip this section.
The High-Low/Pattern Option switch is used to control the function of the Green w/Red wire.
The Green w/Red wire is normally used for Pattern Programming
(see next page)
. If you
are using the Dim feature, AFTER PROGRAMMING YOUR FLASH PATTERNS, flip this
switch into the ON position (DOWN in the diagram above). When +12VDC is applied to the
Green w/Red wire, the light will dim.
