Star Headlight & Lantern LCS653, Инструкция по установке и эксплуатации

Страница: 10 / 20

-8-
(Electrical Connections CONT’D)
BLUE LEAD (PIN #11) - Used for YELP control
SS651: Connect the Blue lead to terminal 1b of SW1 (next to
WAIL label)
LCS653/LCS653-1: Connect the Blue lead to terminal 1b of SW3 (next to
WAIL label)
SS651MT: Connect it to the Blue wire from the SS651MT switch
panel.
Be sure to use minimum size #18 AWG wire.
Optional Connections:
GREEN LEAD (PIN #10) - Used for remote or auxiliary HORN control
This wire is used in vehicles with a positive-side switched horn to synchronize
the vehicle horn and the siren horn (similar to the Orange wire on vehicles with
negative [ground-side] switched horns).
Connect the Green wire to the +12 VDC switched horn ring circuit. Both the
vehicle horn and the siren horn will be activated when the horn in the vehicle is
pressed. When the HORN button on the control head is pressed (SS651 and
LCS653 only), only the siren horn will sound.
NOTE: If you are not using this lead, cut it short &
insulate it with electrical tape.
CONNECTION OF CONTROL HEADS
SS651MT-CH
The SS651MT-CH control head comes with 8’ leads. They will be connected to the
appropriate wires from the SWH-36 or lights by soldering or using appropriate
connectors (user supplied) and/or additional wire when necessary. Refer to the
diagram below.
SS651-CH (for SS651), SS651-CH3 (for LCS653-1), and
SS651-CH4 (for LCS653)
•
Electrical power connections to the SS651-CH control head are made using the
1/4" quick connect terminals provided.
•
After your wires are run from the location of the siren amp to the location of
the control head, crimp the enclosed terminals on to the ends of the wires and
plug them into the appropriate terminals on the back of the control head.
Testing - Test all siren functions after installation to assure proper o peration.
Test vehicle operation to assure no damage to vehicle.
Siren Amp Pin 1
Siren Amp Pin 6
Siren Amp Pin 9
Siren Amp Pin 11
Power to Beacon
Power to Front Lights
BEACON
YELP
PHASER WAIL FRONT
LIGHTS
Red (#12 AWG)
Brown (#18AWG)
Ground
Orange (#18 AWG)
Yellow (#18 AWG)
Red (#18 AWG)
Blue (#18 AWG)
Gray (#18 AWG)