STANNOL INDUSTA HF, Руководство по эксплуатации

Страница: 27 / 82

27
operATINg INSTrUcTIoNS
SeTUp AND geNerAL INSTrUcTIoNS
1. IroN STAND
caution: Before using the sponge, it needs to be moistened. It should not be too wet, so
squeeze the sponge before use. Using the sponge dry may cause damage to the sponge and
the tip. Instead of a sponge brass wool can be used.
●
Place moistened sponge into the front frame of the soldering iron stand.
●
Add water to the iron frame from time to time to keep the sponge wet.
●
Rinse the sponge from time to time in fresh water.
2. coNNecTIoN
caution: Always turn off the soldering station before connecting or disconnecting the sol-
dering iron.
● Connect the plug from soldering iron cable to the output socket of the
soldering station (Ext.).The plug is polarized, so it cannot be connected the
wrong way. After inserting the plug tighten the lock nut clockwise.
● Place the soldering iron into the iron stand.
●
Connect the mains cable to the “Input” socket on the back of the soldering
station.
●
Plug in the mains cable into the main socket.
● Turn the power switch. The soldering iron will automatically heat up to a
stable temperature (factory set to 320 °C). During heating the heating indi-
cation in the Display is flashing.
●
Press the * key for less than 1 second, the display will show the current set
temperature for 2 seconds.
● ESD protection: if necessary connect a ground terminal antistatic wrist
strap to the „ ESD” socket on the back of the station.
●
Information: The ESD socket is hard wired to the mains ground.
01
02
Alignment after
insertion. Tightened
clockwise.
Heating lamp