14- ENG
2. Use the adjustable pressure regulator to increase and
decrease the pressure.
Refer to the
Adjustable Pressure Regulator
Adjustment
paragraph.
NOTICE: DO NOT
attempt to increase pump pressure. A higher pressure setting than
the factory set pressure may damage pump.
ADJUSTABLE PRESSURE REGULATOR ADJUSTMENT (FIG. 6, 7)
1. Choose the correct high pressure nozzle (0˚, 15˚ or 40˚)
for the job to be performed.
Refer to
How To Use Spray Wand
.
2. The adjustable pressure regulator is shipped in the MAX pressure setting, the MAX
pressure bar is aligned with the arrow (R) on the collar as shown in Figure 6.
Rotating the adjustable pressure regulator (L) counterclockwise until it stops places
it in the MIN pressure setting, the arrow (R) will align with the MIN pressure bar as
shown in Figure 7.
7
R
L
6
R
Adjust the pressure by rotating the
adjustable pressure regulator (L)
clockwise for higher pressure or
counterclockwise for lower pressure,
aligning the arrow with the desired
pressure bar on the adjustable
pressure regulator.
NOTE:
To apply chemicals the black low pressure nozzle must be installed and the
adjustable pressure regulator must be in the MAX pressure setting.
HOW TO USE SPRAY WAND
The nozzles for the spray wand are stored in the nozzle holder on the panel assembly.
Colors on the panel identify nozzle location and spray pattern. Refer to the following chart
to choose the correct nozzle for the job to be performed.
CHANGING NOZZLES ON SPRAY WAND (FIG. 8)
DANGER: Risk of fluid injection. Do not direct discharge stream
toward persons, unprotected skin, eyes or any pets or animals.
Serious injury will occur.
WARNING: Flying objects could cause risk of serious injury. Do not
attempt to change nozzles while pressure washer is running. Turn
engine off before changing nozzles.
1. Pull quick-connect coupler (E) back and insert
8
K
E
P
nozzle (K) or (P).
2. Release quick-connect coupler and twist nozzle to
make sure it is secure in coupler.
Job Name: 31925 FNA STANLEY 7108823 MANUAL
PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017.p14.pdf
Process Plan: Tabloid Pdf Proof HI-RES - NO TRIM LINES
Date: 17-03-14
Time: 14:59:44
Operator: ____________________________
PageMark-BW-Comp
❏
OK to proceed
❏
Make corrections and proceed
❏
Make corrections and show another proof
Signed: ___________________ Date: ______
Job Name: 31925 FNA STANLEY 7108823 MANUAL
PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017_DBL.p14.pdf
Process Plan: Tabloid Pdf Proof HI-RES With TRIM LINES
Date: 17-03-14
Time: 15:03:14
Operator: ____________________________
PageMark-BW-Comp
❏
OK to proceed
❏
Make corrections and proceed
❏
Make corrections and show another proof
Signed: ___________________ Date: ______
