Stanley SXAE00125, Руководство пользователя

Страница: 6 / 164

6
2.3. Charging the booster
2.3.1. Checking the level of the internal battery
Slide the ON/OFF switch to the ON position. The LCD display will show the battery’s percentage of
charge. A fully charged internal battery will read 100%. Charge the internal battery if the display shows
it is under 85%.
2.3.2. Charging the internal battery
Charge the unit as soon as possible after use. Never completely discharge the battery.
Use a 2A USB charger (not included), or a 2A USB charging port to quickly recharge the booster.
Using a charger with less than 2A will increase charge time.
1. Plug the Micro USB end of the charging cable into the input port. Next, plug the USB end
of the charging cable into a charger’s USB port
2. Plug your charger into a live AC or DC power outlet.
3. The LCD display will light; the digit begins to flash and show “IN”, indicating that charging
has begun.
4. The booster will be fully charged in about 4 hours (with 5V DC, 2A charging input). When
the unit is fully charged, the display will show “100%”.
5. When the battery is fully charged, disconnect your charger from the outlet, and then remove
the charging cable from the charger and the unit. Slide the ON/OFF switch to the OFF position,
if you are not using the unit immediately.
2.4. Using the LED light
1. Slide the ON/OFF switch to the ON position.
2. Hold down the power button for 3 seconds.
3. Once the LED light is on, press and release the power button to cycle through the following
modes:

Steady glow

Flash for an SOS signal

Flash in strobe mode
4. When finished using the LED light, press and hold the power button until the light turns off.
5. Slide the ON/OFF switch to the OFF position.
6. Recharge the unit as soon as possible after each use.
3. Instructions manual
3.1. To start a vehicle
IMPORTANT:

Do not use the booster while charging its internal battery.

Using the booster without a battery installed in the vehicle will damage the vehicle’s electrical
system.

Only jump start a 12V lead-acid battery system vehicle.
NOTE: The internal battery must have a charge if at least 40% to jump start a vehicle.
Turn OFF ignition and all electrical devices (heating, lighting…) before using the booster.
Lay the DC cables away from any fan blades, belts, pulleys and other moving parts.
1. Connection to the booster - Stand-by mode
Plug the battery clamp smart cable into the booster’s output socket. The green LED is flashing
on the smart cable, which means that the booster is in “Jump Start Stand-by mode”.