Stanley STDH7213, Руководство пользователя

Страница: 8 / 16

8
ENGLISH
ton (2) and release the variable speed switch.
This option is available only at full speed.
u
To switch the tool off, release the variable speed
switch. To switch the tool off when in continuous
operation, press the variable speed switch once
more and release it.
u
Based on the different applications, turn around
the speed dial (11) to control the maximum
speed.
Drilling in metal
Start drilling with slow speed and increase to full
power while applying firm pressure on the tool.
A smooth even flow of metal chips indicates the
proper drilling rate. Use a cutting lubricant when
drilling metals. The exceptions are cast iron and
brass which should be drilled dry.
NOTE: Large [5/16" (8 mm) to 1/2" (13 mm)] holes
in steel can be made easier if a pilot hole [5/32"
(4 mm) to 3/16" (5 mm)] is drilled first.
Drilling in wood
Start drilling with slow speed and increase to full
power while applying firm pressure on the tool.
Holes in wood can be made with the same twist
drills used for metal. These bits may overheat
unless pulled out frequently to clear chips from the
flutes. Work that is apt to splinter should be
backed up with a block of wood.
Drilling in masonry
When drilling in masonry, use carbide-tipped bits
rated for Impact drilling and be certain that
the bits are sharp. Use a constant and firm force
on the tool to drill most effectively. A smooth, even
flow of dust indicates the proper drilling rate.
Screwdriving
u
Select forward or reverse rotation.
Impact drilling (fig. A)
u
Select the Impact mode.
u
Press the switch (1).
Rotary drilling (fig. A)
u
Select the rotary drilling mode.
u
Proceed as described for Impact drilling.
Consult your dealer for further information on the
appropriate accessories.
Accessories
The performance of an electric tool depends on
its accessories. Stanleyaccessories are designed
according to high quality standards, to enhance
the performance of electric tool. The use of these
accessories can help you conveniently operate the
tool.
Maintenance
The Stanleycord / cordless appliance / tools are of
sophisticated design, can be used for a long time,
and only little maintenance is needed. To obtain
consistent satisfactory use, proper maintenance
and regular cleaning of the tools are necessary.
Warning! Before performing any maintenance
work on the cord / cordless electric tools, the fol-
lowing points must be implemented:
u
Switch off the power of the equipment / tools
and pull off the plug;
u
If the equipment / tools are equipped with inde-
pendent battery pack, please turn off the power
and remove the battery pack from the equip-
ment / tools.
u
If the equipment / tools are equipped with an
integrated battery, please run out the battery,
before turning off its power.
u
Before the cleaning, unplug the charger plug
from the power source. In addition, except
the regular cleaning on your charger, no other
maintenance is needed.
u
Regularly use the soft brush or dry cloth to
clean the ventilation slot of the equipment /
tools / charger.
u
Regularly use a damp cloth to clean the motor
housing. Please do not use any abrasive clean-
ing agents or solvent-based cleansing agents.
u
Regularly open the clamping chuck and tap it
gently to remove any internal dust (after instal-
lation).
Cleaning
Warning! Once the visible dust build-up
is found at and/or around the ventilat-
ing ports, immediately flush the dust and
powder within the host shell with clean dry
air. To perform this procedure, wear the
approved safety equipment and dust mask.