SK58 User
Manual ◄ 15
MAINTENANCE
UNDERWATER MODEL
MAINTENANCE
After each use, the movable portions of the tool that
were exposed to water should be flushed with a water
displacing oil, such as WD40™. Remove water and
debris as follows:
1.
Turn the tool upside down (without the tool bit) and
spray oil through the drive hex and displace any
remaining water in the lower cavity.
2.
Dip or spray the entire tool.
3. Cycle the tool hydraulically several times before
storing away.
GENERAL SERVICE NOTES
1.
If the breaker is repainted after servicing, be sure to
mask off the vent in the valve cap assembly. Do not
allow paint to enter the IN and OUT ports or the bore
of the foot assembly.
2. If the handle grips need to be replaced.
a.
Remove the old grips and clean the handle.
b.
Wash the new grips and the handle clean and
dry, simply push or drive the grips on. DO NOT
lubricate the parts. The grips will not be secure
on the handle if any grease or oil is used.
