Stanley RW30110, Руководство пользователя

Страница: 21 / 40

21
OPERATION
Set Position O4:
-In mode « ALIGNMENT OK »
Position O4 must be vertical from Position O1.
When the beads number has been modified:
The step is bigger than the maximum allowed step. Raise the
number of beads.
The step is smaller than the minimal allowed step. Reduce
the number of beads.
These 2 values can be modified in the parameters menu.
The number of beads must be superior at 3.
Show an inappropriate calculation not allow by the software.
UNVALID POINT
RETURN TO PO1
ERROR !!!
SPACING > xx.x mm
ERROR !!!
SPACING < xx.x mm
ERROR
BEADS NUMBER > 3
DIV ERROR