Stanley RW30110, Руководство пользователя

Страница: 17 / 40

17
OPERATOR DIALOGUE
Power up:
Then:
Change language - press the arrows:
Display software version and Charlie serial number.
This mode allows to perform free polygons from 3 to 4
sides.
• Setting the points without restriction (beads direction :
Position O1 to Position O2).
• When setting the 4 points, point 4 can be out of the vertical
alignment of point Position O1; without automatic control of
any alignment.
• Welding mode « bead by bead ».
Simple welding mode: Shapes like rectangle, triangle and
butt welding.
• Non stop welding our bead by bead.
• Realization with or without surrounding.
Changing welding modes by pressing:
OPERATION
Memories Test
HELLO
or
CTRL.PROG x.xxx
CHARLIE Nxxxxxxx
NO ALIGNMENT
ALIGNMENT
OK
or
Validate by pressing:
Corrections can be made by pressing:
Note: This is also effective during all welding cycle.
To go to the next step, press:
To step back to the previous step, press:
Welding speed displayed cm/min (1 cm/min equals to 0.4
inch/min) (adjustable value in the parameter menu).
Allow to move the torch according into 2 axis « X » et « Z ».
Set point Position O1. Define the resurfacing area.
Set point Position O2. The torch cans only moves on the «
X » axis.
ALIGNMENT
OK
SPEED : 30
cm/mn
LAYER 1
TORCH: PO1
PO2
TORCH:
PO3
TORCH: