Tool operators and maintenance personnel must always comply with the safety precautions given in this
manual and on the stickers and tags attached to the tool and hose.
These safety precautions are given for your safety. Review them carefully before operating the tool and
before performing general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specifi c work area and local
safety regulations. If so, place the added precautions in the space provided on page 3.
GENERAL SAFETY PRECAUTIONS
The models PP10 Hydraulic Post Puller will provide safe and dependable service if operated in accor-
dance with the instructions given in this manual. Read and understand this manual and any stickers and
tags attached to the PP10 before operation. Failure to do so could result in personal injury or equipment
damage.
• Operator must start in a work area without bystanders. The operator must be familiar with all prohib-
ited work areas such as excessive slopes and dangerous terrain conditions.
• Establish a training program for all operators to ensure safe operation.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor.
• Always wear safety equipment such as goggles, ear and head protection, and safety shoes at all times
when operating the tool.
• Do not inspect or clean the tool while the hydraulic power source is connected. Accidental engage-
ment of the tool can cause serious injury.
• Always connect hoses to the tool hose couplers before energizing the hydraulic power source. Be
sure all hose connections are tight.
• Do not operate the tool at oil temperatures above 140
°
F/60°C.
Operation at higher temperatures can
cause higher than normal temperatures at the tool which can result in operator discomfort.
• Do not operate a damaged, improperly adjusted, or incompletely assembled tool.
• Stay clear of all moving parts.
• Never wear loose clothing that can get entangled in the working parts of the tool.
• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be
performed by authorized and properly trained personnel.
• System pressure hose must always be connected to the tool “IN” or “P” port and system return hose
must be connected to the tool “OUT” or “T” port. Reversing connections or reversing fl ow to the tool
can
result in severe personal injury.
• Never use tools near energized transmission lines. Know the location of buried or covered services
before starting your work.
SAFETY PRECAUTIONS
2
