Stanley Oisin Eco, Инструкция по установке и эксплуатации

Страница: 8 / 20

CHIMNEY
The Oisin must be connected to a chimney of the
proper size and type. The chimney must have a
diameter of at least 150mm. Never connect to a
smaller size chimney. Do not connect to a chimney
serving another appliance. The stove is supplied
with a 5” flue spigot, the flue installation will require
a 5” to 6” increaser which must be fitted within 1.5
meters of flue outlet. Minimum chimney height 15’
(4.6 meters) from floor on which stove is installed. A
flue that has proved to be unsatisfactory, particular-
ly with regard to down draught should not be used
for venting this appliance until it has been examined
and any faults corrected. An existing masonry chim-
ney should be inspected and if necessary repaired
by a competent mason or relined using an approved
lining system. The stove must be connected to a
chimney with a minimum continuous draught of 0.06
w.g. Poor draught conditions will result in poor per-
formance.
All register plates, restricter plates, damper etc.,
which could obstruct the flue at a future date should
be removed before connecting this appliance. If con-
necting to an existing chimney with a flue diameter
of more that 8” it is recommend to line the flue using
a suitable stainless steel flue liner.
8
To minimise the wind effects, the flue termination
point should be located in accordance with building
regulation part J (See Fig.5), Where this termination
point does not suffice it may be necessary to extend
the flue pipe so that the termination point is above
the apex. For further information please refer to
building regulations part J.
FLUE EXIT (TOP & REAR)
TOP FLUE EXIT
For the top outlet configuration, remove the blank-
ing plate from the hob, remove the flue spigot from
the back plate and fix it to the hob. Fix the outlet
blanking plate to back plate (see Fig. 3). Push the
flue outlet connector pipe (not supplied) into the flue
spigot and cement into place using approved fire
cement ensuring that no cement blocks the flue pas-
sageway.
REAR FLUE EXIT
Push the flue connector pipe (not supplied) into the
flue spigot and cement into place using approved
fire cement ensuring that no cement blocks the flue
passageway (see Fig.4).
Stainless Steel
chimney
Connector
Insulated
non-combustible
throat sealer
Fig.2
Flue Liner
Fig.3
Fig.4