Stanley MAEVE, Инструкция по эксплуатации, установке и обслуживанию

Страница: 3 / 16

1. GENERAL
1.1 Installation and servicing must only be
carried out by a competent person.
1.2 In all correspondence, please quote the
appliance type and serial number which
can be found on the data badge located at
the rear of the stove.
1.3 Ensure that curtains are not positioned
above the stove, and that there is at least
a clearance of 300mm between the sides
of the stove and any curtains.
1.4 If any cracks are observed in the glass
panel, do not use the appliance until the
glass has been replaced.
2. LIGHTING THE STOVE
2.1 Ensure the control is pointing to the off
2.2 Depress control knob and rotate anti-
clockwise until a click is heard and the
knob is pointing at the ignition symbol (
*
),
the pilot should now be lit.
2.3 Depress for 5 to 10 seconds and then
release, the pilot should remain alight. If
the pilot does not light, repeat the above
procedure.
2.4 If it will not light after repeated attempts,
contact the retailer or installer from whom
the appliance was purchased.
2.5 The appliance may now be turned to the
high position to ignite the main burner,
then controlled between high and low as
desired.
3. TURNING THE STOVE OFF
3.1 Depress the control knob and turn clock-
wise until the knob is pointing at the off
NOTE: THE YELLOW FLAMES WILL
APPEAR WHEN THE FIRE HAS GAINED
SUFFICIENT HEAT - TYPICALLY 10 TO
20 MINUTES.
IF THE APPLIANCE IS EXTINGUISHED
OR GOES OUT IN USE, WAIT 3 MIN-
UTES BEFORE ATTEMPTING TO RE-
LIGHT THE APPLIANCE.
4. CLEANING THE STOVE
4.1 Remove the ceramic coals and place on a
dry, clean surface. Remove the front coal
ceramic, please handle with care.
4.2 Clean the flame baffle ceramic piece and
burner using a vacuum cleaner with soft
brush attachment, ensure all debris are
removed from the burner ports.
4.3 Replace the ceramics by referring to
Section 5.
5. ARRANGEMENT OF FUEL-BED COM-
PONENTS
The major ceramic components can be
found inside the firebox, remove the cast
iron door and remove all the protective
packaging from these components.
NOTE: THE CAST IRON DOOR IS
HEAVY, TAKE EXTREME CARE WHEN
HANDLING.
The loose coals should be arranged as
specified in the following steps, care
should be taken to ensure that there is
sufficient space between the coals to
allow flames to pass through.
5.1 Place the flame baffle onto the shelf at the
rear of the tray and push up against the
rear ledge, see Fig 11.
5.2 Locate the front coal moulding in front of
the flame baffle ensuring that the end legs
sit flat against the burner skin, see Fig 12.
5.3 Place three large coals on the front coal
so that they lean against the flame baffle,
and four large coals on the flame baffle so
that they sit on the fingers, see Fig 13.
5.4 Place two small coals at each end of the
front coal so that they lean against the
flame baffle, and a further two large coals
on the flame baffle, one at each end, see
Fig 14.
5.5 Place five small coals along the rear of
the flame baffle, resting against the rear
ledge, see Fig 15.
NOTE: ENSURE THAT THE COALS ARE
POSITIONED, AS DETAILED ABOVE.
ONLY USE THE CORRECT AMOUNT OF
COALS, AS SPECIFIED IN THE DIA-
GRAMS.
INSTRUCTIONS FOR USE
2
position ( ).
position ( ).