Stanley Fatmax FMC021, Руководство пользователя

Страница: 7 / 80

7
ENGLISH (Original instructions)
u
Slide the speed selector (6) towards the front of the tool
(2nd gear).
Speed selector (fig. E)
u
For drilling in steel and for screwdriving applications, slide
the speed selector (6) towards the rear of the tool (1st
gear).
u
For drilling in materials other than steel, slide the speed
selector (6) towards the front of the tool (2nd gear).
Drilling/screwdriving
u
Select forward or reverse rotation using the forward/
reverse slider (2).
u
To switch the tool on, press the switch (1). The tool speed
depends on how far you press the switch.
u
To switch the tool off, release the switch.
LED work light
The LED work light (7) is activated automatically when the
trigger is depressed. The LED work light will illuminate when
the trigger is partially depressed, before the unit begins
running.
Hints for optimum use
Drilling
u
Always apply a light pressure in a straight line with the drill
bit.
u
Just before the drill tip breaks through the other side of the
workpiece, decrease pressure on the tool.
u
Use a block of wood to back up workpieces that may
splinter.
u
Use spade bits when drilling large diameter holes in wood.
u
Use HSS drill bits when drilling in metal.
u
Use masonry bits when drilling in soft masonry.
u
Use a lubricant when drilling metals other than cast iron
and brass.
u
Make an indentation using a centre punch at the centre of
the hole to be drilled in order to improve accuracy.
Screwdriving
u
Always use the correct type and size of screwdriver bit.
u
If screws are difficult to tighten, try applying a small
amount of washing liquid or soap as a lubricant.
u
Always hold the tool and screwdriver bit in a straight line
with the screw.
Maintenance
Your Stanley Fat Max tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
u
Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
u
Regularly clean the motor housing using a damp cloth.
u
Do not use any abrasive or solvent-based cleaner.
u
Regularly open the chuck and tap it to remove any dust
from the interior.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com.
Technical data
FMC021
Voltage V
DC
10.8
No-load speed Min
-1
0-400, 0-1500
Max. torque
(PTI Rating)
Nm 26
Impact Rating bpm 0-6000 0-22500
Chuck capacity mm 10
Max Drilling capacity
Steel/wood/
masonry
mm 10/20/8
Weight kg 1.0
Charger
N472239/N472243
Input Voltage V
AC
230
Output Voltage
V
DC
22
Current A 1.25
Approx. charge time min
70 (1.5AH)
Battery
FMC086L
Voltage V
DC
10.8
Capacity Ah
1.5
Type Li-Ion