8
ENGLISH
9
ENGLISH
n
12 volt Dc charger (optional accessory)
Input:
12VDC
Output:
6VDC (550mA)
Fuse:
2A/250V
lIMIted Warranty
Manufacturer issues this limited warranty to the original purchaser of this product. This
limited warranty is not transferable and is only valid for non-commercial use. Manufacturer
warrants this unit for 2 years from the date of purchase against defective workmanship
or material. It is the obligation of the purchaser to forward the unit together with proof of
purchase to the manufacturer or its representative with transportation cost prepaid. This
warranty is void if the unit is abused, handled carelessly or repaired by anyone other than
manufacturer or its authorized representative. Manufacturer makes no warranty other than
this limited warranty and expressly excludes any implied warranty including any warranty
for consequential damages. This is the only expressed limited warranty and manufacturer
neither assumes nor authorizes anyone to assume or make any other obligation towards
the product other than this limited warranty.
Baccus Worldwide LLC
Weena 290
3012 NJ Rotterdam or
Postbus 819, 3000 AV Rotterdam
12 volt dc charger plug fuse replacement
The fuse in the plug end of the DC charger protects the adapter’s charging circuit. If the mains
AC charger operates, but the DC charger does not, then this fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 2 amp/250 volt fuse.
5. Replace the fuse, spring, contact and end cap.
6. screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the DC charger.
ProtectIng the envIronMent
correct disposal of this product
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased.
They can take this product for environmentally safe recycling.
separate collection of used products and packaging allows materials to be
recycled and used again. Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for raw materials.
Local regulations may provide for separate collection of electrical products from the
household, at municipal waste sites or by the retailer when you purchase a new product.
technIcal data
Light
Light bar:
26 bright white LEDs, 1 red LED
Battery:
Maintenance-free, NiMH
3.6 volt, 1.3 Ah
Ac Mains charger (Eu and GB models)
Input:
220-240 VAC
Output:
6VDC (600mA)
BF0109EU_Manual_040612.indd 8-9
4/6/2012 12:00:05 PM
