Stanley 76501-02000, Руководство пользователя

Страница: 40 / 85

7
Troubleshooting Guide
Problem Possible Cause Action
Pump will not start when “ON/ADV”
button is depressed No power Connect power
Pump on-off switch in “OFF” position Move switch to “ON” position
Circuit breaker tripped Push circuit breaker button
Low voltage Turn off other electric loads
Use heavier gauge extension cord
Motor brushes worn to end of life See Section 6.3, Motor Brush Replacement
Pendant damage Repair pendant
See authorized service center
Motor stops under load Low voltage Turn off other electric loads
Use heavier gauge extension cord
Electric valve will not operate No power to pump or wrong voltage Connect to correct power source per pump
nameplate
Solenoid cable disconnected or damaged Connect, repair, or replace cable
Solenoid coil not operational See authorized service center
Valve out of adjustment See authorized service center
Pump fails to build pressure or less
than full pressure Low oil level Add oil per section 4.4
Relief valve set too low Adjust per section 5.7
External system leak Inspect and repair or replace
Internal leak in pump
See authorized service center
Internal leak in valve
Internal leak in system component
Pump builds full pressure, but torque
wrench does not advance Torque greater than wrench capacity at full pressure Use torque wrench with larger capacity
Advance fl ow to wrench restricted or blocked Check couplers for full engagement per section 4.5
Torque wrench will not retract Return fl ow line restricted or blocked Check couplers for full engagement
Run motor when retracting
Valve malfunction See authorized service center
Pressure trapped in hoses after
pump motor stops Pressure not relieved Relieve pressure per section 5.4
Pump runs hot Advance or retract fl ow restricted Check couplers for full engagement per section 4.5
High ambient temperature Install heat exchanger