1 – 16
Getting Started
•
Interface reset. When an interface is reset, all connections on
that interface are reset to the power-on state. To reset the GPIB
interface, use the [
←
] and [
→
] keys to switch from
to
,
and then press the [Enter] key. The message “
”
will briefly display on the screen as confirmation that the inter-
face has been reset.
•
GPIB Address. The SR470 GPIB address may be set to any
value from 0 to 30. The current value will be displayed as (for
example)
when the GPIB address is 8. Press the [
←
] and [
→
] keys to
adjust the address number.
A change in this parameter will not take e
ff
ect until the SR470
is power cycled or the interface is reset.
1.2.6.3 Ethernet
The SR470 comes standard with an RJ-45 network communications
port located on the rear panel. The port may be used to communicate
with the SR470 over a 10
/
100 Base-T ethernet connected network or
LAN. Any changes to the interface configuration will not take e
ff
ect
until the SR470 is power cycled or the interface is reset.
The ethernet menu can be accessed by pressing [Shift][ENet]. Use
[
] and [
] to navigate between menu items. The menu items are:
•
Ethernet interface on or o
ff
. Press the [
←
] and [
→
] keys to
switch between
and
,
which indicate, respectively, that the ethernet (TCP
/
IP) inter-
face is enabled or disabled.
•
Interface reset. When an interface is reset, all connections on
that interface are reset to the power-on state. To reset the eth-
ernet interface, use the [
←
] and [
→
] keys to switch from
SR470 Shutter Controller
