15
- Adjustment mode -
This transceiver must be adjusted in the adjustment mode. How to start up the adjustment mode is described below.
(a) Turn off the transceiver's power switch.
(b) Turn on the power switch while holding down the DIAL key and LAMP key at the same time. At this point, the "Adj XX"
(XX : channel number) indication on the LCD of the transceiver.
AdJ XX (XX : channel number)
Turn on the power switch while holding down
the DIAL key and LAMP key at the same time.
While holding down the LAMP key,
press the H/L key.
Hi Po Adj mode
Threshold SQL Adj mode
While holding down the LAMP key,
press the MONI key.
Lo Po Adj mode
Turn on the rotary switch
while holding down the LAMP key.
Turn on the rotary switch
while holding down the LAMP key.
Press the MONI key to
write into the memory.
Tight SQL Adj mode
Press the MONI key to
write into the memory.
Cancel :
While holding down
the LAMP key,
press the H/L key.
Cancel :
While holding down
the LAMP key,
press the H/L key.
Skip :
While holding down
the LAMP key,
press the MONI key.
Cancel :
While holding down
the LAMP key,
press the MONI key.
- For the HX290UKA -
Figure 4-2 Test mode flowchart
Transceiver HX290
DC 7.2 V (6 to 12 V)
To RS232C Port
(9 pin)
Personal computer
Interface cable
Figure 4-1 PPS programming connection diagram
Note :
When performing programming, connect the transceiver
to the personal computer with the interface cable.
Содержание HX290U
