Page 21
HX300E
6. BASIC OPERATION
6.1 INITIAL SETUP
1. Install the battery pack on the transceiver (see section “
4.2.2 BATTERY
INSTALLATION/REMOVAL
”).
2. Install the antenna onto the transceiver; hold the bottom end of the an-
tenna, then screw it onto the mating connector on the transceiver until it
is snug. Do not over-tighten.
6.2 RECEPTION
1. Press and hold the
key for two seconds to turn the radio “on”.
2. Press the key twice (“
SQL
” will be blinking).
3. While “
SQL
” is blinking, press the
key until the
“
” indicator will appear on the display, then
press the
key.
4. Press the key (“
VOL
” will be blinking).
5. While “
VOL
” is blinking, press the
/
key until
the noise or audio from the speaker is at a comfort-
able level, then press the
key.
6. Activate the squelch adjusting mode by pressing the
key twice (the “
SQL
” indicator blinks). Press the
key until the random noise disappears, then
press the
key. This state is known as the “Squelch
Threshold”.
7. Press the
or
key to select the desired chan-
nel. Refer to section “
10. VHF MARINE CHANNEL
ASSIGNMENTS
” for available channels.
8. When a signal is received, adjust the volume (press
the key, followed by the
/
key) to the de-
sired listening level. The “
” indicator in the LCD
is displayed indicating that the channel is being used
or the radio is not squelched.
