Standard Horizon HX290, Руководство пользователя

Страница: 23 / 44

Page 23 HX290
6.9 SCANNING
The HX290 has two methods of scan, Memory Scan and Priority Scan (de-
fault).
Memory Scan mode, scans channels programmed into Preset Channel Memory
and also Scan Channel Memory. Priority Scan mode, scans channels pro-
grammed into Preset Channel Memory, Scan Memory and the priority channel
(Channel 16).
When an incoming signal is detected on one of the channels during scan, the
transceiver will pause on that channel, allowing you to listen to the incoming
transmission. The transceiver will automatically start scanning again after the
transmission stops.
6.9.1 SELECTING THE SCAN TYPE
1. Turn the transceiver off by rotating the VOL knob fully counter-clockwise.
2. Hold down the key, and then turn on the transceiver
while still holding down the key.
3. “
SEt
” will appear on the display, indicating the Menu
(“Set”) Mode has been activated.
4. Press the key, repeatedly if necessary to select the
Menu item “
SC
”.
5. Press the or key to select “
PS
(Priority Scan)” or
“
MS
(Memory Scan)”. The factory default is “
PS
(Priority
Scan)”.
6. After completing your selection, turn the transceiver off
and on by rotating the VOL knob.
“M
EMORY
” S
CAN
Preset
Channel “4”
Preset
Channel “3”
Preset
Channel “0”
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel “1”
Preset
Channel “2”
“P
RIORITY
” S
CAN
Preset
Channel “4”
Preset
Channel “3”
Preset
Channel “0”
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel “1”
Preset
Channel “2”