HX290
Page 10
4. GETTING STARTED
4.1 RADIO CARE
CAUTION
Before following the instructions below, insure the battery pack is in place
and firmly connected. Care must be taken if the radio was dropped and
a close inspection may be needed to insure the radio case and gaskets
are in adequate condition.
The design of the
HX290
allows water to enter between the radio and the
battery pack, however waterproof performance is not compromised.
After using the
HX290
in salt water environment is recommended to clean the
radio with fresh water by rinsing the battery and radio (separately) under a sink
facet or by dunking in a fresh water. After washing, use a soft cloth to thor-
oughly dry all parts of the radio and battery.
This will keep the radio parts and the battery clean and in top operating condi-
tion.
4.2 BELT CLIP, HAND STRAP INSTALLATION AND REMOVAL
To install the Belt Clip: align the Belt Clip to the groove of the Battery pack,
then press the Belt Clip downward until it locks in place with a “
Click
.”
To remove the Belt Clip: press the Belt Clip Tab away from the battery pack
to unlock the Belt Clip, then slide the Belt Clip upward to remove it.
To install the Hand Strap: slide
the small loop of the Hand Strap
through the belt clip as shown
below. Next slide big loop on the
Hand Strap inside the small loop
and pull tight.
Belt Clip Tab
Содержание HX290
Страница 1: ...Page 1 HX290 HX290 Floating Marine Transceiver Owner s Manual ...
Страница 9: ...Page 9 HX290 MEMO ...