Standard Horizon HX280S, Руководство пользователя

Страница: 12 / 44

HX280S Page 12
4.2.2 BATTERY INSTALLATION/REMOVAL
ˆ To install the battery pack, hold the transceiver with your left hand, so your
palm is over the speaker and your thumb is on the top of the belt clip. Insert
the battery pack into the bat-
tery compartment on the back
of the radio while tilting the Belt
Clip outward, then push the
bottom side of the battery pack
until the battery pack locks with
the Battery Pack Latch.
ˆ To remove the battery, turn the radio off. Slide the Battery Pack Latch on
the bottom of the radio, then slide the battery downward and out from the
radio while holding the Belt Clip.
4.2.3 BATTERY CHARGING
1. Turn the transceiver off.
2. Insert the DC plug from the
NC-90B into
the DC jack on the CD-46 side panel, then
plug the NC-90B into the AC line outlet.
3. Insert the HX280S (with the battery pack)
into the CD-46 ; the antenna should be at
the left side when viewing the charger from
the front.
4. If the HX280S is inserted correctly, the
Red “ CHARGING ” indicator will glow. A
fully-discharged pack will be charged com-
pletely in approximately 7 hours.
5. When charging is completed, the red LED
indicator will change to green. Remove the
transceiver from the
CD-46 , and unplug
the NC-90B from the AC line outlet.
CAUTION
The CD-46 is NOT designed to be waterproof. Do not attempt to charge
in water hazardous locations.
NOTE
The CD-46 is only designed for the charging of the HX280S ’s battery,
and is not suitable for other purposes. The CD-46 may contribute noise
to TV and radio reception in the immediate vicinity, so we do not recom-
mend its use adjacent to such device.
NC-90B
CD-46
Tilt the Belt Clip
Insert the Battery Pack
Push the bottom side of
the battery pack