page 14
Owner’s Manual
GX1250SA
4.4
CMB16 FLUSH MOUNT INSTALLATION
1. Make a rectangular template for the flush mount measuring 2
inches (50 mm) H x 5 3/8" inches (135 mm) W.
2. Use the template to mark the location where the rectangular hole is
to be cut. Confirm the space behind the dash or panel is deep
enough to accommodate the transceiver (at least 6 inches deep).
There should be at least 1/2 inch between the transceiver’s heatsink
and any wiring, cables or structures.
3. Cut out the rectangular hole and insert the transceiver.
4. Fasten the brackets to the sides of the transceiver with the lock
washer nut combination, so that the mounting screw base faces the
mounting surface (see Figure 5).
5. Turn the adjusting screw to adjust the tension so that the
transceiver is tight against the mounting surface.
Bracket
Adjusting screw
Lock-washer nut combination
Figure 5. CMB16 Flush Mount Installation
