Stamina Aero Pilates Performer 271, Руководство пользователя

Страница: 15 / 23

The safety and integrity designed into the
AeroPilates ® Performer 271
can only be maintained when
the AeroPilates ® Performer 271 is regularly examined for damage and wear. Special attention should
be given to the following:
STORAGE
MAINTENANCE
15
1. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
2. Worn or damaged components should be replaced immediately or the AeroPilates® Performer 271
should be removed from service until repair is made.
3. Verify that the CAUTION LABEL(53) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(53) if it is missing or damaged.
4. Verify that the ROPES(18) are properly installed on the PULLEY SETS(22).
5. Check the condition of the ROPES(18) and replace if they are frayed or worn.
6. Check the
PLASTIC SNAP HOOKS(19)
on the ends of the
ROPES(18).
Replace the
PLASTIC
SNAP HOOKS(19) if they are damaged or deformed.
7. Check the TENSION CORDS(10, 11). If any of the TENSION CORDS(10, 11) are stretched and
loose, re-tie the knot on the end of the cord. Replace TENSION CORDS(10, 11) that are frayed or
worn.
8. Check the
BUNGEE CORD(52)
on the
CARDIO REBOUNDER(50)
for wear. Replace the
BUNGEE
CORD(52) if it is frayed or worn.
9. Check the PULLEY SETS(22) for excessive wear. Replace worn PULLEY SETS(22).
10. Check the HAND/FOOT STRAPS(20) for damage. Replace damaged parts.
11. Check the FOAM SLEEVE(6) and FOAM PADS(17) and replace if damaged or worn.
12. Check the
STOP PLATES(29)
for looseness or damage and replace any damaged parts.
13. Check the CUSHION(14) and replace if it is damaged or worn.
14. Check and clean the ROLLERS(8) and the rolling surfaces on the rails. Clean by wiping with a dry
cloth.
15. Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates®
Performer 271.
16. Keep your AeroPilates® Performer 271 clean by wiping it off with an absorbent cloth after use.
1. To store the AeroPilates ® Performer 271, simply keep it in a clean dry place.
2. The FRONT FRAME(1) of the AeroPilates ® Performer 271 has built-in wheels for easy moving. To
move, be sure at least one of the tension cords is attached to prevent the CARRIAGE(7) from sliding,
then lift from the end of the
REAR FRAME(2)
and roll.
3. The AeroPilates ® Performer 271 folds for storage. To fold, be sure no tension cords are attached
and slide the CARRIAGE(7) to the end of the REAR FRAME(2) . Remove the FOOTBAR(5), CARDIO
REBOUNDER(50), and FOAM PAD ASSEMBLIES(17) , then lift the AeroPilates ® Performer 271
onto its side with the LOCKING PIN(28) side up. With the machine hinging in the middle, move the
FRONT FRAME(1)
toward the
REAR FRAME(2)
until the frame ends meet. Insert the
LOCKING
PIN(28) into the hole in the REAR FRAME(2) , and the AeroPilates ® Performer 271 is ready to
store.