ASSEMBLY INSTRUCTIONS
9
1.
2.
STEP 8
Install the
HEIGHT ADJUSTMENT BEAM(6)
into
MAIN FRAME(4)
by pulling the
LARGE SPRING PIN(18)
on the
MAIN FRAME(4)
and inserting the
HEIGHT ADJUSTMENT BEAM(6)
as shown. For added safety,
thread the
LOCKING KNOB(19)
into back side of the
MAIN FRAME(4).
WARNING:
STEP 9
Attach the
NYLON STRAP(27)
onto the
BUCKLE
on the end of the
BUCKLE STRAP(28)
by inserting the
end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 10
Hook the end of the
NYLON STRAP(27)
onto the loop on the back of the
MAIN FRAME(4).
Hook the end
of the
BUCKLE STRAP(28)
onto the loop on the
FRONT FRAME(1).
NOTE:
A.
C.
B.
BUCKLE
Do not use the
Gravity Inversion Therapy Table
until you have verified your height setting.
Failure to use the proper height setting can result in difficulty recovering from the decline position.
See
HEIGHT ADJUSTMENT
instructions on page 10.
The
NYLON STRAPS
are used to control the decline angle of the
Gravity Inversion Therapy
Table.
For a steeper decline angle, lengthen the straps. For a smaller decline angle, shorten the
straps. Make sure these
NYLON STRAPS
are tight in the buckle and check the decline angle
before using the
Gravity Inversion Therapy Table.
Содержание 55-1532
Страница 14: ...PRODUCT PARTS DRAWING BACK FRONT 14 ...
Страница 17: ...NOTES 17 ...
