Stamina 55-1529A, Руководство пользователя

Страница: 9 / 18

ASSEMBLY INSTRUCTIONS
Shaft
Shaft
STEP 10:
Attach the
LINKAGES(7)
onto the
LEFT
and
RIGHT PIVOT ARMS(5, 6)
with
BOLTS
(M8 x 25mm)(46), WASHERS(M8)(51),
and
NYLOCK NUT(M8)(49).
DO NOT OVER TIGHTEN THE
BOLTS.
STEP 11:
Slide the
LEFT
and
RIGHT PROTECTIVE COVERS(26, 27)
onto each side of the
BASE
ASSEMBLY,
and pull the covers down until the bottom of the covers are slightly lower than the
FOLDING
LINKAGES(3).
Make sure the
SHAFTS
on the
FRONT FRAME(1)
poke out through the hole on the
PROTECTIVE COVERS(26, 27).
Secure the
PROTECTIVE COVERS(26, 27)
to the
FOLDING
LINKAGES(3)
with the
SECURING STRAPS
on the covers.
NOTE: When the
PROTECTIVE COVERS(26, 27)
are assembled correctly the
FOLDING LINKAGES
(3)
should not be visible.
STEP 12:
Attach the
LEFT
and
RIGHT HANDRAIL ASSEMBLYS(8, 9)
onto the
SHAFTS
in both
sides of the
FRONT FRAME(1)
and then connect to the
LINKAGES(7)
with the
LOCKING KNOBS(11).
STEP 13:
Verify that the handlebars function correctly before using the
Assisted Inversion Pro.
Move
the Nylon Bed on the
MAIN FRAME(4)
backward toward the inverted position. The
HANDRAILS(10)
must move forward as the
MAIN FRAME(4)
moves backward. If the
HANDRAILS(10)
do not move
forward check
ASSEMBLY STEPS 2, 10, 11, and 12.
9
Nylon Bed