ASSEMBLY INSTRUCTIONS
9
STEP 5
Attach the
FOOTREST(8)
onto the
HEIGHT ADJUSTMENT BEAM(6)
with
BOLTS(M8x1.25x50mm)(34),
WASHERS(M8)(38),
and
NYLOCK NUTS(M8x1.25)(36).
NOTE:
STEP 6
Insert the
PAD TUBE(9)
through the hole on the
HEIGHT ADJUSTMENT BEAM(6)
and secure with
BOLT(M6x1x45mm)(32)
and
NYLOCK NUT(M6x1)(35).
Place a
HEEL HOLDER BRACKET(10)
onto a
HEEL HOLDER(11),
then slide them onto
PAD TUBE(9)
together. Slide another set of
HEEL HOLDER
BRACKET(10)
and
HEEL HOLDER(11)
over the other end of the
PAD TUBE(9).
STEP 7
Attach the
ADJUSTABLE INSTEP FRAME(7)
to the
HEIGHT ADJUSTMENT BEAM(6)
by pulling the
SMALL SPRING PIN(13)
and sliding the
ADJUSTABLE INSTEP FRAME(7)
completely into the
HEIGHT
ADJUSTMENT BEAM(6).
Insert the
BOLT(M6x1x45mm)(32)
halfway through the square tube on the
HEIGHT ADJUSTMENT BEAM(6),
slide the bolt through the ring at the bottom of the
SPRING(12),
slide the
bolt through the square tube and secure with
NYLOCK NUT(M6x1)(35).
Press the
SQUARE PLUG(40)
into
the
HEIGHT ADJUSTMENT BEAM(6).
Install a
HEEL HOLDER BRACKET(10)
and
HEEL HOLDER(11)
onto both sides of the
ADJUSTABLE INSTEP FRAME(7).
The five holes in the
FOOTREST(8)
allow the
FOOTREST(8)
to be attached in three different
positions. Start with the center position and adjust if necessary. Use the outer position if users are
taller than average. Use the inner position if users are shorter than average.
Содержание 55-1527
Страница 16: ...PRODUCT PARTS DRAWING 16 FRONT BACK ...
