ASSEMBLY INSTRUCTIONS
15
STEP 5:
There is a strap attached inside of the
HANDLEBAR POST(13)
to assist in pulling the
CONTROL
CABLE(103)
and
CONNECTING WIRE(104)
through the
HANDLEBAR POST(13).
Tie the strap to the plug
ends of the
CONTROL CABLE(103)
and
CONNECTING WIRE(104).
Pull the strap from the top end to pull
the cables to through and extend out from the hole at the front of the
HANDLEBAR POST(13)
as shown in
the below illustration. Loosen and pull the
UPRIGHT LOCKING LEVER(49),
then insert the
HANDLEBAR
POST(13)
into the
MAIN FRAME(1).
Insert the pin of the
UPRIGHT LOCKING LEVER(49)
into one of the
adjustment holes in the
HANDLEBAR POST(13).
Tighten the
UPRIGHT LOCKING LEVER(49)
to lock the
HANDLEBAR POST(13)
in position.
NOTE:
Don’t remove the strap from the
CONTROL CABLE(103)
and
CONNECTING WIRE(104)
until
instructed to do so in later assembly steps.
STEP 6
NOTE:
The
RIGHT PEDAL(23)
has right hand threads and is tightened by turning clockwise. The
LEFT
PEDAL(17)
has left hand threads and is tightened by turning counterclockwise.
Thread the
RIGHT PEDAL(23)
into the
RIGHT CRANK(22)
as shown. The shoulder of the
RIGHT PEDAL(23)
must
be in contact with the
RIGHT CRANK(22)
.
Tighten the pedal securely or it
will
come loose and fall
off during use and strip the threads.
Do the same to attach the
LEFT PEDAL(17)
to the
LEFT CRANK(18).
CAUTION:
Check that the
PEDALS
(23,17)
are fully tightened prior to each use. If the pedals are not tight
against the cranks they will come loose and fall off during use.
Strap
Shoulder
Shoulder
Use the Combination Wrench to
securely tighten the LEFT PEDAL
(17) by turning counterclockwise.
Use the Combination Wrench
to securely tighten the RIGHT
PEDAL(23) by turning clockwise.
Содержание 15-8100
Страница 1: ...Bike We do the thinking you do the moving O W N E R S M A N U A L...
Страница 28: ...PRODUCT PARTS DRAWING 28 FRONT BACK...
Страница 33: ...NOTES 33...
