Stallion CWI-B1412, Руководство по установке и эксплуатации, Страница: 8 / 25

Initial Cleaning
The cast iron table is covered with a special protec-
tive coating to prevent rusting during shipping. Re-
move this coating using a rag and solvent (mineral
spirits or paint thinner). Most of the coating can be
carefully scraped off with a putty knife before solvent
cleaning. Take care not to scratch the table when
scraping.
Bandsaw Assembly
Do not apply solvent to painted metal or plastic sur-
faces as this could damage these surfaces. Once
the protective coating has been removed, a surface
protector such as paste wax should be applied to the
table for additional protection and to reduce friction
between the workpiece and table during operation.
Use a screwdriver and solvent soaked rag to clean
the coating out from the miter slots.
M ounting the Table
When the bandsaw table is installed, the trunnions on
the underside of the table (A) rest in the saw frame’s
trunnion supports (B), and the left side of the table rests
on the table tilt stop bolt (C).
8
A
A
C
B
B
To install the table, first remove the table’s pin (D).
D