Stallion CWI-B1412, Руководство по установке и эксплуатации, Страница: 16 / 25

Connecting to a Dust Collector
It is essential to always use a proper dust collection
system when operating the saw. There is a 4" dust
outlet located on the rear of the saw for connection to a
dust collector (A).
A
Dust Collector Connection
To clean out dust trapped inside the saw cabinet, open
the wheel cover doors and vacuum out the inside of the
cabinet (B).
B
Ball Bearing Guides
For simplified guide setup,optional ball bearing guides
can be purchased from your CWI distributor. The bear-
ing guides install on the same dovetail mount as the
included ceramic guides, but are less prone to dam-
age from improper setup.
Guide Depth from Gullet
Like the ceramic guides, the front edge of the roller
guides should be set 1/16” behind the blade’s gullet.
To adjust this distance, loosen the allen screw (A) and
slide the guide assembly backwards or forwards as
required (B). Retighten the allen screw once depth is
set.
Rotate the wheels by hand to ensure 1/16” clearance
is maintained along the entire blade, and re-adjust if
necessary.
Guide Distance from Blade
The guides should just touch the blade when the saw
is off (C). During operation, the roller bearings should
spin along with the blade to help guide it during cut-
ting. Position the guides by loosening the allen screws
(D) and sliding the guides along their dovetail mounts.
Rotate the wheels by hand to ensure the guides just
touch the blade throughout its entire length, and re-
adjust if necessary.
D
D
C
16
A B