- 10 -
EN
7. TROUBLESHOOTING
Troubleshooting in case of faults
Problem
Solution
The appliance does not work,
the display is not illuminated
Check whether the plug is inserted in the mains socket properly.
Check whether the fuse is not damaged or faulty.
The freezer works too loudly
Check whether the furniture and objects placed nearby are not vibrated due to the compres-
sor's operation. Please note that noise from the refrigerant flow cannot be avoided.
Check whether the appliance is stably positioned on the floor.
The temperature is too high
Check whether a separate external thermometer shows correct values.
Check whether ventilation system works properly and whether the ventilation grate is not
blocked or dirty.
Check whether too much fresh food has been put into the freezer. Check the temperature again
after 24 hours.
Check whether the freezer is not too close to heat sources.
If the above actions bring no result please order a repair by a specialized service provider.
8. TRANSPORT AND STORAGE
The device is protected by a protective film, placed on a wooden pallet and packed in a cardboard box
•
A packed unit should be stored in a sheltered environment at an ambient temperature of -25°C/+55°C and humidity of 30-95%
•
Do not stack more than 2 devices on top of each other
•
Please refer to the data plate on the appliance. In case of damage or loss of the nameplate, replace it immediately. Do not
unscrew the safety guards.
•
Make sure that the installation site has adequate surface area for proper ventilation and operation. After unpacking, carefully
remove the protective film and other safety components applied during transport.
•
Place the unit on a flat floor and level with the adjustable feet.
•
When lifting the device by means of a jack, the jack must be placed on the outside of the frame; after.
•
Transporting the unit, wait about 2 hours before restarting it.
•
Secure the door of the appliance with a key lock.
•
Do not place the appliance near flammable products, outdoors or in direct sunlight.
9. DISPOSAL OF THE OLD APPLIANCE
Information for users on the rules concerning proper disposal of electrical and electronic equipment at the end of its life.
•
Leave your old equipment in the shop where you purchase a new appliance.
Each store is obliged to accept old equip-
ment free of charge if you buy there the new equipment of the same type and in the same quantity. The only condition is to
deliver the old equipment to the store at your expense.
•
Dispose of your old equipment at a collection point.
Information about the location of the nearest collection point can be
found on the local website or the notice board of the municipal office.
•
Leave the equipment at a service point.
If the repair of the equipment is unprofitable or impossible for technical reasons,
the service is obliged to accept this appliance free of charge.
•
Return the used equipment at the end of its life without leaving your home.
If you do not have the time or ability to deli-
ver your equipment to the collection point, you can use the services of specialized companies.
•
Remember! Do not dispose of used equipment together with regular waste.
An illegal or incorrect disposal of the product will lead to high penalties being imposed.
The symbol of a crossed-out rubbish bin on the product, its packaging or its instruction manual means that at the
end of its life the product must not be disposed of with regular waste. The user is obliged to deliver their used equip-
ment to a designated collection point for proper processing.
10. GUARANTEE
The dealer of the appliance is liable under the guarantee.
The guarantee does not cover any damage resulting from the build-up of limescale inside the appliance. The guarantee also does
not cover: damage caused by external forces such as atmospheric discharge, voltage change, incorrect setting of electrical vol-
tage, power supply from unsuitable power outlet, any mechanical, thermal, chemical damage and defects resulting from them.
Furthermore, the guarantee does not cover the replacement of exhaustible parts, namely: light bulbs, rubber elements, heating
elements damaged by limescale, glass and other elements that are exposed to any form of wear or usage, for example; burners,
rubber units as well as any breakdowns or mechanical damage of the appliance elements caused by incorrect storage, transport,
maintenance, installation or operation.
Содержание 883101
Страница 11: ......
