- 5 -
6. OPERATION
1.
Make sure that the temperature controller is set to the „0” position;
2.
Fill the tank with water to at least half of its capacity;
3.
Put the lid on;
4.
Connect the plug to the electrical socket;
5.
Set the temperature controller to the desired temperature;
6.
The heating element will begin heating the liquid and the control lamp will light up when the heating process is comple-
ted;
7.
If the water temperature decreases by ~ 5-10°C below the temperature set by the user, the heater will activate automa-
tically in order to heat the water to the set temperature; The control lamp will light up.
Caution:
If the temperature of the device is set to over 100°C or near that temperature, the device will boil constantly until
the temperature is reduced by the user.
7. CLEANING AND MAINTENANCE
Time intervals between successive activities consisting in the removal of limescale depend on the intensity of use of the device
and the hardness of the water (the harder the water, the more frequent descaling is recommended).
Before removing the limescale, wait until the device cools down, because its components are very hot after operation.
Use commercially available descaling agents to descale the device. Remember to always rinse the device at least once after
descaling.
The manufacturer assumes no liability for any malfunctions caused by excessive limescale buildup. It is recommended if the
water exceeds the hardness of 6°dh in the German degree of hardness.
8. DISPOSING OF USED EQUIPMENT
You can return your old device after the end of use or when buying a new device at Stalgast. Send the device to us and a
specialized company will dispose of it in accordance with the Waste Electrical and Electronic Equipment Act (Journal of Laws
of 2005, No. 180, item 1495).
9. WARRANTY
The seller shall be liable under the warranty or guarantee.
Use water with a hardness of up to 6°dh in the German degree of hardness.
In the event of damages resulting from
the formation of lime scale deposits in the device, they are not subject to repair under warranty. The warranty does not cover
damages caused by external forces such as lightning, changes in supply voltage,
incorrect setting of the voltage value, supply from an inadequate power outlet, mechanical, thermal, chemical damages to the
equipment and the defects caused by them.
Warranty exchange does not cover such elements as: light bulbs, rubber components, heating elements damaged by lime
scale, screws and elements subject to natural wear, e.g. burners, rubber seals and all kinds of mechanically damaged elements.
